Continental LCA85BYI0 Manual De Usuario página 29

Installation of water inlet hose
On models having an inlet hose with a single threaded connector
1
Unscrew four screws of part A and sleeve part A horizontally over the mouth at the end
of water tap (the mouth at the end of water tap must be flat and smooth. Flatten it by fil-
ing if it is not flat) and push it upward with force making the rubber washer firmly press
the plane center of water tap mouth. Then tighten the screw sequentially. After that,
tightly screw on part B.
A
B
The connection socket consists of A and B
two parts. Before installation, A and B two
parts must be unscrewed about 5 mm, or
directly disconnected. If the bore of water
tap is larger, remove the plastic junk ring
of part A.
6
Connect
2
Small Ball
Push down the slide jacket to ex-
pose the small balls and enable
separation of connector socket
from speedy connector.
4
Anillo
5 mm
To connect: Push down the slide jacket of
speedy connector (4 small balls must be
exposed), insert it into the connection
socket and then push upward. Release the
connection of water tap with speedy con-
nector completely. If it is required to feed
water, simply open the water tap.
To disconnect: Close the water tap, push
down the slide jacket of speedy connector
and pull out the speedy
connector.
3
5
7
Disconnect
29