Cleaning, Maintenance, Storage And Order; Carbon Brushes; Ordering Replacement Parts; Disposal And Recycling - Toolson DKS1600 Traducción De Las Instrucciones Originales De Funcionamiento

• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connec-
tion cables with the marking H 05 VV-F, 3x1.0 mm
The printing of the type designation on the connec-
tion cable is mandatory.
AC motor
• The mains voltage must be 220-240 V ~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm .
2
Connections and repairs of electrical equipment may
only be carried out by an electrician. Please provide
the following information in the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate
10. Cleaning, maintenance, storage
and ordering of spare parts
Important.
Always pull out the power plug before starting any
cleaning work.
10.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
• We recommend that you clean the equipment im-
mediately after you use it.
• Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
• Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plastic
parts in the equipment. Ensure that no water can
get into the interior of the equipment.
10.2 Servicing
There are no parts inside the equipment which re-
quire additional maintenance.
10.2.1 Bearing(s) (Fig. 1/Item 8)
Periodically lubricate the bearings (8) of the guide
rollers with high-grade machine grease, at the latest
however after 25 to 30 hours of operation.

10.2.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician. Im-
portant: The carbon brushes should not be replaced
by anyone but a qualified electrician.
10.3 Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing tem-
perature. The ideal storage temperature is between 5
and 30 °C. Store the electric tool in its original pack-
aging.

10.4 Ordering replacement parts

The following information must be provided on all or-
ders for spare parts:
. • Model/type of the equipment
2
• Article number of the equipment

11. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
GB 25