Ecco Smartspot Instrucciones De Instalación Y Funcionamiento página 11

2. The settings interface is divided into several parts:
Part A is connection setup. COM port is used to select the COM port number for connection when you select COM mode.
Part B is Control Box configuration, which is used to set up the detection zone length, width (Type 1 sensor cannot be set), trigger output
length and buzzer starting zone.
Part C is showing the install angle of sensor.
Part D is to select the number of sensors to use with the control box for the desired application (one or two)
Part E combination display is selected only if two sensors are being used.
Part F is updating function.
Part G is version info that shows the current version of the firmware (information only)
Figure 18
View of the settings when set-up is complete on a single sensor system View of the settings when set-up is complete on a dual sensor system
Figure 19 Figure 20
Page 11 of 16