Sensor Installation - Ecco Smartspot Instrucciones De Instalación Y Funcionamiento

6. Installation:
Check the contents of the shipping package and make sure the following items are included:
1 (or 2) Sensor(s)
1 Control Box
1 Buzzer (within 1m: 75.8db, 0.1m: 91.5db)
1 3m Monitor Transmission Cable
1 (or 2) 3m Sensor Transmission Cable(s)
1 0.9m USB to UART Cable
1 (or 2) Sensor Bracket(s)
1 USB Thumbdrive Camera Cable (included with camera kit, sold separately)
Buzzer

6.1 Sensor Installation:

The radar sensor mounting location is important for proper installation. Ideally, the sensor should be mounted on the rear center of the
vehicle at roughly 3ft +/- 0.1ft (1m +/- 0.03m) above the ground and angled up 5° using the Silicone Pad. The sensor can be adjusted
horizontally with the mounting bracket.
IMPORTANT!
Before the Radar Detection System is permanently installed to the vehicle, verify that the sensor mounting location provides a
clear detection zone. Temporarily attach the sensor in the proposed mounting location, apply power to the system and verify that
nothing is being detected (ex: rear of the vehicle).
Monitor & camera systems are sold separately
Connect Sensor Transmission Cable to Port C
and Camera Transmission Cable to Port D
on the Control Box
Figure 2
5˚
Figure 3
5˚
Figure 4
(When mounted higher than 3ft/1m)
Page 4 of 16