Operating Precautions; Product Features; Technical Specifications - Ecco Smartspot Instrucciones De Instalación Y Funcionamiento

1. Operating Precautions:

1. The device may be powered by a 12 or 24 volt automotive battery or vehicle electrical system.
2. Improper connection of the system or power supply will damage the sensor and control box.
3. The system should be tested properly for daily operations before the vehicle or equipment is used.
4. The radar detection system is intended for use on commercial vehicles and equipment. Proper installation requires a good understanding
of vehicle or equipment's electrical system and procedures.
!
WARNING:
1. Do not open the product. This can cause damage, short-circuiting or electrical shock that could lead to serious injury or
death.
2. The equipment is not an alternative to safe driving practices.
3. Install a plug sealer on any control box port that is not use.
4. Yellow wire (alarm output) must be isolated to prevent short-circuiting if not in use.

2. Product Features:

1. Advanced microwave sensing technology.
2. Automatically activated when the driver shifts vehicle into reverse.
3. Customizable detection zones and alarm trigger with computer interface.
4. The device is capable of visualizing the radar zones on the display. As soon as an object enters the detection zone it will activate a
transparent colored visualization alert on the display to make the driver aware of the potential danger. (Green - Far, Yellow - Middle, Red -
Close).
5. Detects moving objects including any transportation vehicles, motorcycles, bicycles, pedestrians, etc.
6. Works effectively in harsh environments and in poor visibility including darkness, smoke, fog and dust.
7. Within 1 meter: 85.5db, 0.1 meter: 96db, this alarm box includes buzzer and detection zone overlay for viewing on the camera monitor.
If driver disconnects the buzzer, the detection zone overlay will flash when approaching an object.

3. Technical Specifications:

1. Radar sensor frequency: 73.00 to 79.00 GHz
2. Transmitter Type: FMCW.
3. Power Supply: 12 to 24 VDC.
4. Detection Range: 0.1-20m, up to 5 detection zones (distance of each zone can be configured).
5. Detection Zone Visualization: Green (furthest), Yellow(middle), Red (closest).
6. Detection Tolerance: +/-30cm.
7. Antenna Beam Angle: 100° (Horizontal), 40° (Vertical).
8. Trigger Input ×1 : Trigger from vehicle, high active
Range above +10 VDC, up to supply voltage.
9. Alarm Output ×1: Switched to Ground when activated
Capacity up to 1.0A.
10. Video format: standard CVBS compatible with worldwide NTSC, PAL
11. Operating Temperature: -20 to +70°C.
12. Storage Temperature: -30 to +80°C.
13. IP Rating: IP66 (sensor)
14. Vibration Rating: 5.9G
15. Dimensions: Sensor: 106.6(W) ×72.9(H) ×34.5(D) mm.
Control Box: 152.6(W) ×89.2(H) ×53.8(D) mm.
16. Weight: 154.6Grams (sensor) 240Grams (control box)
17. Mounting: Two (4.5mm) diameter mounting holes (sensor)
Four (6mm) diameter mounting holes (control box)
18. Buzzer: within 1m: 75.8db, 0.1m: 91.5db
19. Monitor: within 1m: 83.3db, 0.1m: 91.5db
20. Thumb drive provided with required drivers for Windows 10 and MAC and firmware for configuration of system.
Page 2 of 16