Operation And Maintenance; Technical Parameters - GRAPHITE 59G261 Manual Del Usuario

● Putting the working pad away from processed surface during operation will allow dust to get out of the
tool into the room where the work is carried out.
● Efficiency and quality of processed surface depend heavily on type of sanding paper used and applied
pressure. It is best to match the type of sanding paper by trials and errors.
● When finishing sanding reduce pressure on the sander, switch off the motor and vacuum cleaner.
● Replace sanding paper when you observe signs of wear.
● Make periodic breaks in operation.
Do not switch the sander on while its working pad is pressed against processed surface.
Disconnect the tool from power supply network before starting any adjustment, maintenance or
repair.
● Always keep the sander clean.
● Do not use water or any other liquid for cleaning.
● Use brush to clean the sander.
● Clean ventilation holes of the sander regularly to prevent motor overheating.
● In case of excessive commutator sparking check technical condition of carbon brushes of the motor.
● Store the sander in a dry place, beyond reach of children.
WORKING PAD REPLACEMENT
Replace immediately worn out or damaged working pad.
● Loosen and unscrew the bolt that fixes the working pad (8) (fig. H).
● Replace the working pad with a new one, fix with the bolt.
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both carbon brushes at a time.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be
used.
All defects should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Supply voltage
Current frequency
Rated power
Range of spindle rotational speed without load
Sander length
Diameter of working pad
Diameter of sanding paper
Spindle thread
Protection class
Protection level
Weight
Year of production

OPERATION AND MAINTENANCE

TECHNICAL PARAMETERS

Long Reach Sander
Parameter
16
Value
230 V AC
50 Hz
600 W
600-1500 min
-1
1100-2000 mm
225 mm
225 mm
M6
II
IP20
5,5 kg
2019