Troubleshooting - Hamilton Beach 54614 Manual Del Usuario

840154500 ENv03.qxd
Optional Cleaning
1. Remove spout assembly lever by
2. Wash spout assembly and parts in hot,
soapy water. Rinse and dry thoroughly.
Do not soak.
NOTE: Do not remove seal rings
from spout adaptor.

Troubleshooting

PROBLEM
Blender leaks.
Ice not crushed.
Does not
blend well.
Does not dispense.
Spout assembly
leaks.
Cannot remove
cutting assembly.
8/30/06 3:11 PM Page 7
rotating coun-
terclockwise.
PROBABLE CAUSE/SOLUTION
• Tighten cutting assembly on jar.
• Make sure gasket is in place on cutting assembly.
• Make sure gasket is not damaged. If damaged, please
call our toll-free customer service number to order a
replacement.
• Make sure lid with filler cap is pushed down tightly on
jar.
• See ice crushing instructions in "Blending Specific
Foods" section.
• Make sure enough liquid has been added. A minimum
of 10 ounces (300 ml) is recommended.
• Make sure blender is ON.
• Make sure seal rings are in place on spout adaptor.
• Tighten spout assembly lever (located above spout
assembly body).
• Loosen collar by holding jar and turning cutting
assembly counterclockwise.
3. Reassemble plunger inside of spout
body and rotate spout assembly
lever clockwise until tight.
Spout
Assembly
Lever
Spout
Adaptor
Plunger
Spout
Assembly
Body
Seal Rings
7