cam QUANTICO Manual Del Usuario página 11

quantico 6 dic 2017 15 lingue_Layout 1 06/12/17 15:52 Pagina 11
(max 30°), with a mild neutral detergent. Do not tumble dry, do not
iron, and do not use solvents. Should any problems arise during the
fitting, or use of this product, contact the manufacturer. Please note
that group 1-2-3 stage car seats can be used on the front seat and are
exempt from the regulation of not being fitted when an airbag is
active, as per Regulation ece R 44. We would however recommend that
this car seat only be used on the rear seat of your vehicle. For safety
reasons, this instruction booklet, must be kept in the pocket situated
at the rear of the car seat at all times. Use of the car seat is subject to
standard ece R 44. certain limitations prevail over this standard and are
imposed by local or national laws. Do not leave your child unattended
in the car seat. Always check that your child has been fastened in the
car seat correctly. Every so often during the journey check that your
child has not loosened himself from the seat. Do not use second-hand
products, because the background of the product is not known. Do
not lubricate the moving parts of the car seat. Do not leave the car
seat in the car under the sun: the plastic and metal parts could
overheat. Cover the car seat if the car is parked under the sun. Do not
remove the logos of the product to avoid damaging the fabric. Most
accidents happen in town: always use the car seat even for short
journeys. Before buying the product, always check that the car seat
can be fitted properly in your car. All passengers must wear seat belts.
Stop often for breaks during long journeys so that baby is free to move
about. Observe the highway code of your country.
1.COMPONENTS
1.Headrest
2.Armrests
3.Cup holder
4.ISOFIT connectors
release button
5.Headrest adjustment
handle
6.Belt guide – headrest
7.Belt guide – seat
8.ISOFIT connectors
9.Shell
HOW TO FIT THE CAR SEAT
2. Fit the car seat so that it is
forward facing. Do not use on
front seats fitted with front
airbags. Do not fit on seats
provided with two-point seat
INSTRUCTIONS FOR USE
belts. This car seat can only be
fitted on seats provided with a 3-
point seat belt standard approved
according to UN/ECE Regulation
N. 16 or an equivalent.
3. Press the ISOFIT connectors
release button and, at the same
time, pull the connectors to
extract them completely.
4. Fasten the ISOFIT connectors to
the Isofix hooks on the seat of the
car. A click should be heard on
both sides.
Note: the car seat can also be
fitted without
connectors. The connectors can
be fully retracted so that the car
seat can also be fitted on seats
without IsoFix connectors.
the ISOFIT
10