Publicidad
Idiomas disponibles
Idiomas disponibles
I. Assembly of widths of comfort underlay (2 people are needed):
Note: Prepare a clean area to lay the underlay and the carpet on the building floor or on the exercise floor.
1 - Assembly without exercise floor: determine the position of the complete gymnastics area by marking out the
perimeter of the carpet on the floor, i.e. a square measuring 14 x 14 m (Check diagonal length: 19.80 m). Next, mark
out a second square inside for the underlay measuring 13.50 x 13.50 m (Diagonal length: 19.09 m). Accordingly there
is an offset of 25 cm between the 2 around the perimeter (see Fig. 2).
Assembly with exercise floor: the underlay is exactly the same size (13.50 x 13.50 m) as the floor.
2 - Unroll 1 width of foam (1) aligned with one side of the outline or the exercise floor, starting from a corner, as shown in Fig. 1.
3 - Position the other 8 widths (1) edge to edge, taking care not to disturb the first one.
Should any widths (1) exceed the 13.50 m length, cut off the ends in line with the outline or the exercise floor (see Fig. 1),
using a rule at least 2 m in length, and a cutting tool of the utility knife type (be careful not to damage the underlying floor).
Figure 1
1.50 1.50 1.50 1.50 1.50 1.50 1.50 1.50 1.50
1
1
4 - Ensure that the widths (1) fit together closely before joining them such that the underlay forms a single piece, as shown
in Fig. 3. Unroll the adhesive tape (2) (5 cm wide) at right angles to the direction of the widths, to create 7 strips, spaced
at approximately 1.60 m. Apply the strips (2) over their full length.
II. Disassembly:
1 - Separate the widths of comfort under
lay by cutting the joints made with the
adhesive.
2 - Roll up the widths separately.
14 m
13.50 m
1
1
1
1
1
Figure 3
1
1
Outline of the
underlay perimeter
Outline of the
carpet perimeter
Figure 2 (View from Above)
14 m
13.50 m
NM93d - Page 2
Figure 2
2
2
2
2
2
2
2
Publicidad
