Operation; Maintenance - Gardena ComfortCut 550/50 Instrucciones De Empleo

To connect the front handle [ Fig. A1 ]:
(1)
1. Push the front handle
Make sure that the front handle
the handle hole is inline up with the threaded hole.

3. OPERATION

DANGER! Risk of injury!
Cut injury when the product starts acciden-
tally.
v Disconnect the product from the mains and
slide the protective cover over the blade before
you connect or transport the product.
To connect the hedge trimmer [ Fig. O1 ]:
CAUTION! Risc of electric shock!
To avoid damage to the mains cable
extension cable
(5)
the cable lock
v Before you operate the product insert the exten-
(4)
sion cable into the cable lock
v Never take hold of the protective cover when
connecting the product.
1. Loop the extension cable
(5)
cable lock and pull tight.
(6)
2. Connect the plug of the product into the socket
of the extension cable.
3. Connect the extension cable
socket.
Work positions:
The product can be operated in 3 positions.

4. MAINTENANCE

DANGER! Risk of injury!
Cut injury when the product starts
accidentally.
v Disconnect the product from the mains and
slide the protective cover over the blade before
you do maintenance.
into the slot in the product.
(1)
is fully in place and
(3)
the
(4)
must be inserted into
.
(5)
.
(4)
, insert the loop into the
(4)
into a 230 V mains
2. Put both screws
Do not push the start button
3. Tighten both screws
Make sure that the screws
the start button
• Side trimming [ Fig. O2 ]
• High trimming [ Fig. O3 ]
• Low trimming [ Fig. O4 ]
To start the hedge trimmer [ Fig. O5 ]:
DANGER! Risk of injury!
Risc of injury if the product does not stop
when you release the start button.
v Do not bypass the safety devices or switches.
For example do not attach the start buttons
to the handle.
To start:
The product is fitted with a two-handed safety device
(2 start buttons) to prevent the product from being
turned
on by accident.
1. Remove the protective cover from the blade.
2. Hold the front handle
(9)
start button .
(7)
3. Hold the main handle
the start button
The product will start.
To stop:
1. Release the two start buttons
2. Slide the protective cover over the blade.
To clean the hedge trimmer:
DANGER! Electric shock!
Risk of injury and risk of damage to the
product.
v Do not clean the product with water or with a
water jet (in particular high-pressure water jet).
1. Clean the product with a damp cloth.
2. Clean the airflow slots with a soft brush (do not
use a screwdriver).
3. Lubricate the blade with a low viscosity oil
(e. g. GARDENA Maintenance Oil Art. 2366).
Avoid contact with the plastic parts.
(2) in the threaded hole in the product.
(9) while you doing this.
(2) with a screwdriver.
(2) are fully tightened and
(9) can be fully pushed.
(8)
with one hand and push the
(10)
with the other hand and push
(11)
.
(9) (11)
/ .
(9) / (11)
13