Craftsman 580.752300 Instrucciones De Uso página 13

Ocultar thumbs Ver también para 580.752300:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Apply d etergent toa drysurface, starting a tlower
portion o farea tobewashed and workupward, using
long, e ven, overlapping
strokes.
7. Allow detergent to"soak i n"for3-5minutes before
washing andrinsing. Reapply asneeded toprevent
surface fromdrying. DO NOT a llow detergent todryon
(prevents streaking).
IMPORTANT:
Youmust f lush thedetergent siphoning system
after e ach use byplacing t hefilterintoabucket ofclean
water, thenrunthepressure washer withblack d etergent
nozzle f or1-2minutes.
Pressure Washer Binsing
1.
Remove black detergent nozzle from nozzle extension.
2.
Select and install desired high pressure spray tip
following instructions How to Use Spray Tips.
3.
Keep spray gun a safe distance from area you plan to
spray.
WARHIHG
Kickback from spray gun can cause you to fall.
, Operate pressure washerfrom a stablesurface.
• Be extremely carefulif youmust usethe pressure washerfrom
a ladder,scaffolding,or anyothersimilarlocation.
, Firmlygraspspraygun with bothhandswhenusinghigh
pressure sprayto avoidinjury whenspraygun kicks back.
4.
Increase (decrease) spray pressure by turning pressure
control knob (A) clockwise (counterclockwise). Use
lower pressure to wash items such as a car or boat. Use
higher pressure to strip paint and degrease driveways.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
1.
Remove high pressure spray tip from nozzle extension.
2.
Select and install black detergent nozzle.
3.
Placedetergent siphoning tube/filter in a bucket full of
clean water.
4.
Flush for 1-2 minutes.
5.
Shut off engine following instructions How to Stop
Pressure Washerand turn off water supply.
6.
ALWAYS point spray gun in a safe direction, press red
button and squeezespray gun trigger to release retained
high water pressure.
IMPORTANT:Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARHIHG
The high pressure stream of water that this
equipment produces can cut through skin and its
,_
underlying tissues, leading to serious injury and
)ossible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
, Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYS pointspraygun in safedirection,pressred button
and squeeze spraygun trigger,to releasehigh pressure, e very
time youstop engine.
Automatic Cool Down System
(ThermalRefief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F. The system engagesto cool the pump by discharging
the warm water onto the ground.
5.
Apply a high pressure spray to a small area and then
check the surface for damage. If no damage is found,
you can assume it is okay to continue rinsing.
6.
Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido