Craftsman 580.752300 Instrucciones De Uso página 23

Ocultar thumbs Ver también para 580.752300:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Correction
Pomp has following problems:failure
to producepressure, erratic pressore,
chattering, loss of pressure, low water
volome.
Detergent fails to mix with spray.
Caus8
1.
Low pressure spray tip installed.
2.
Water inlet is blocked.
3.
Inadequatewater supply.
4.
Inlet hose is kinked or leaking.
5.
Clogged inlet hose strainer.
6.
Water supply is over IO0°F.
7.
High pressure hose is blocked or
leaks.
8.
Gun leaks.
9.
Spray tip is obstructed.
10. Pump is faulty.
1.
Detergentsiphoning tube is not
submerged.
2.
Detergentsiphoning tube/filter is
clogged or cracked.
High pressure spray tip installed.
1.
Replacespray tip with high pressure
spray tip.
2.
Clear inlet.
3.
Provide adequatewater flow.
4.
Straighten inlet hose, patch leak.
5.
Checkand clean inlet hose strainer.
6.
Provide cooler water supply.
7.
Clear blocks in outlet hose.
8.
Replacegun.
9.
Cleanspray tip.
10. Contact Searsservice facility.
1.
Insert detergent siphoning tube into
detergent.
2.
Cleanor replace filter/detergent
siphoning tube.
Replacespray tip with low pressure
spray tip.
3.
3.
Engine runs good at no-load hut "bogs" Engine speed is too slow.
Move throttle control to FASTposition, if
engine still "bogs down", contact Sears
when load is added,
service facility.
Engine will not start; or starts and runs
rough.
Engineshuts downduring operation.
Enginelacks power.
Engine "hunts" or falters.
1.
Low oil level.
2.
Dirty air cleaner.
3.
Out of fuel.
4.
Stale fuel.
5.
Spark plug wire not connected to
spark plug.
6.
Bad spark plug.
7.
Water in fuel.
8.
Overchoking.
9.
Excessivelyrich fuel mixture.
10. Intake valve stuck open or closed.
1.
Fiil crankcase to proper level.
2.
Cleanor replace air cleaner.
3.
Fiil fuel tank.
4.
Drain fuel tank; fiil with fresh fuel.
5.
Connectwire to spark plug.
6.
Replacespark plug.
7.
Drain fuel tank; fill with fresh fuel.
8.
Open choke fully and crank engine.
9.
Contact Searsservice facility.
10. Contact Searsservice facility.
11. Engine has lost compression.
Out of fuel.
Dirty air filter.
Choke is opened too soon.
11. Contact Searsservice facility.
till fuel tank.
Replaceair filter.
Move choke to halfway position until
engine runs smoothly.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido