Craftsman 580.752300 Instrucciones De Uso página 6

Your p ressure washer requires some assembly and is ready
foruse onlyafter i t hasbeen properly serviced withthe
recommended oilandfuel.
5. Verify pump oil dipstick (A) has been installed into pump.
If you have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1-800-222-3136.
IMPORTANT:Any attempt to run the engine before it has
been serviced with the recommended oil will result in an
engine failure.
Unpack the Pressure Washer
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
Carton Contents
Checkall contents. If any parts are missing or damaged,call
the pressure washer helpline at 1-888-222-3136.
• The main unit
• Handle
• Spray gun
• High pressure hose
• Nozzleextension with quick connect fitting
• Engine oil
• Parts bag (which includes items listed below)
• Owner's manual
• Registration card
• Bagcontaining 5 multi-colored quick connect spray
tips
• HandleFasteningHardwareKit (which includes):
• Carriage Bolt (2)
• Plastic Knobs (2)
Becomefamiliar with each piece before assembling the
pressure washer. Checkall contents against the illustration
on page 5. if any parts are missing or damaged, call the
pressure washer helpline at 1-888-222-3136.
AssembJingYour Pressure Pasher
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle
extension.
Attach HandJe
1. Placehandle (B) onto handle supports (C) connected to
main unit. Make sure holes (D) in handle align with
holes (D) on handle supports.
NOTE:it may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts (E) through holes from outside of
unit and attach a plastic knob (F) from inside of unit.
Tighten by hand.
3. Insert multi-colored spray tips in spaces provided in
handle.