Haier HMV1472BHS Manual Del Usuario página 18

4. Remove the used charcoal filter from the back of the grille, and then discard the
filter.
5. Align the holes in the new charcoal filter with the five posts on the back of the
grille, and gently press down to attach.
6. Align the top edge of the grille so that when the grille is pushed into place the
screw hole tabs on the the grille will align with the holes in the microwave
cabinet. Gently push on the grille until it snaps into place and the screw holes
are aligned.
NOTE:
Make sure that the wire harness, located near the door hinge, is
not pinched when you are replacing the top grille.
a b
7. Replace the two screws removed earlier, and completely tighten the screws.
Screws (2)
A
a
Charcoal Filter
A
Wire Harness (not shown)
A
Screw Hole Tab (2)
B
16
a
b