Initial Use - Tetra FilterJet 400 Instrucciones

UK

INITIAL USE

NOTE
The pump must not be allowed to run dry. Otherwise it will be damaged.
• Only operate the pump when it is immersed.
Procedure:
Fig. E
• Ensure that there is a bend in the mains connection cable to prevent water
from dripping off it into the socket.
• To switch on the pump: insert the power supply plug in the socket.
• To switch off the pump: pull out the plug.
POSITIONING AND ADJUSTMENT
Procedure:
Fig. F
• Adjusting the air control valve.
– The more you open the air control valve, the more the water is aerated.
• Adjusting water circulation.
– Optimal setting: water circulating throughout the aquarium.
– Important: Do not twist the pump housing so far that it detaches from the
locking mechanism.
MAINTENANCE
Clean the FilterJet 400/600/900 as required (at least twice a year).
Clean the pump/replace the impeller
NOTE
Do not use chemical cleaning agents as these can be harmful to your plants
and the environment.
• Only use clean water or special cleaning products for aquaria.
During cleaning or maintenance, unplug and remove the pump from the aquar-
ium.
14
FilterJet 400/600/900