Improper Use; General Safety Information - wolfcraft FKS 145 Traducción Del Manual De Instrucciones Original

• Other electronic devices apart from circular hand saws (e.g. no angle grinders, no pushcut saws,
no jigsaws, etc.)
• Using mounting carriage without guide rail
• Modifications to mounting carriage
• Using mounting carriage with other rails/ledges
• Using circular hand saws outside the minimum and maximum base plate dimensions
The user is liable for any damage or accidents resulting from improper use.
• DANGER: Disconnect the plug from the electric socket or remove the battery from the power
tool before adjusting the tool or changing accessories. Accidents may occur if the power tool is
started unintentionally.
• Keep your work area clean and well lit. Untidy or dark work areas can lead to accidents.
• Before starting work, check that the devices and tools are operational. Never work with
damaged or blunt tools.
• Remove the adjusting tools or spanners before switching on the power tool. A tool or spanner
left in a rotating part of the device can cause injury.
• Pay close attention. Do not use a power tool if you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention when using the power tool can result in
serious injuries.
• Wear suitable personal protective equipment: ear protection, safety goggles and dust mask
if the work generates dust.
• Wear suitable clothing. Never wear loose clothing or jewellery. Keep long hair, clothing,
jewellery and gloves away from moving parts.
• Keep children and other persons at a safe distance when using the power tool. If you are
distracted, you may lose control of the device.
• When not in use, store power tools out of reach of children. Do not allow persons to use the tool
who are not familiar with it or who have not read these instructions. Power tools are dangerous
if used by unexperienced persons.
• Do not use the tool on materials other than wood or easily machined plastics.
• The machines used must comply with DIN EN 62841-5.
• Only use tools for their actual intended purpose.
• Ensure that the guide rail is used on a stable, level surface.
• The guide rail must not be modified to accommodate other machines on the rail.
• Use only the mounting carriage supplied and no older versions/in-house designs.
• Check regularly that all screws on the mounting carriage are securely fastened.
• Remove the circular hand saw from the mounting carriage in the start/end position only
(with the safety shield closed) and after the saw blade has come to a complete stop.
t

Improper use

General safety information

20