Philips FC6162 Manual Del Usuario página 7

Problem
Dust escapes from the
appliance.
The brush does not turn
anymore.
FC6172, FC6169: The mini
turbo brush does not
function properly.
FC6172, FC6169: I cannot
connect the mini turbo
brush to the appliance.
Possible cause
The filter is dirty.
The brush encounters too
much resistance.
You switched on the
appliance by pressing the on
button on the handheld
vacuum cleaner.
The roller brush is blocked.
The roller brush is blocked by
fabric or surfaces during
cleaning.
The mini turbo brush is not
fully closed.
The connector between the
mini turbo brush and the
appliance is not placed
properly.
The connector between the
mini turbo brush and the
appliance is not present.
Solution
Clean the filter.
Clean the brush with a pair of scissors or
by hand. If you clean the roller brush by
hand, pull the hairs or threads from the
widest side to the narrowest side of the
roller brush (see user manual).
Switch off the appliance by pressing the
on button on the handheld vacuum
cleaner again. Then switch it on again by
pressing the on button on the stick.
Remove hairs from the brush with a pair
of scissors (see user manual).
Keep the mini turbo brush aligned with
the surface and do not push the turbo
brush into soft surfaces.
Make sure that the top and bottom parts
of the mini turbo brush are properly
connected and there is no gap between
the two parts. Check if the locking ring is
in closed position (see user manual).
Make sure that the connector is pushed
into the mini turbo brush as far as it
goes.
You can remove the connector from the
mini turbo brush, for instance for
thorough cleaning, but you cannot
connect the mini turbo brush directly to
the appliance without the connector. To
reassemble the mini turbo brush, first
push the connector into the mini turbo
brush as far as it goes and then push the
connector into the nozzle of the
handheld vacuum cleaner.
English
9