DELANCEY
Pull-Down Bar Kitchen Faucet
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
Flat Blade Screwdriver
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
Turn off water at
CAUTION
main supply
• (A) Installation with ESCUTCHEON (1). (Escutcheon is not supplied with base product). Apply a bead of putty to bottom
edge of ESCUTCHEON with PUTTY PLATE (1). Make certain the SEAL (9) is properly seated in recess of faucet body. Insert
SUPPLY HOSES (2), SPRAY HOSE (7) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and mounting
surface. Follow mounting instructions below to secure faucet to mounting surface.
• (B) Installation less ESCUTCHEON (1). Make certain the SEAL (9) is properly seated in recess of spout base. Insert supply
HOSES (2), SPRAY HOSE (7) and SHANK (3) through mounting hole and seat spout base onto sink or mounting surface.
Do not use putty.
• Insert HOSES (2) through RUBBER
WASHER (4), BRASS WASHER (5),
and threaded LOCKNUT (6).
• Assemble RUBBER WASHER (4),
BRASS WASHER (5), and threaded
LOCKNUT (6) onto SHANK (3)
from underside of sink or
mounting surface. Hand
tighten LOCKNUT (6).
• Use a screwdriver to tighten
SCREWS (8) on LOCKNUT (6).
Work your way around
LOCKNUT (6), tightening
the screws slightly each
time until all are snug
to ensure even pressure.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
™
Phillips Screwdriver
A
(OPTIONAL)
S P O U T B A S E
3
INSTALLATION
INSTRUCTIONS
4279.410
Adjustable Wrench
7
9
1
P U T T Y
2
S I N K O R
M O U N T I N G
S U R FA C E
7
4
5
6
8
- 1 -
Certified to comply with ANSI A112.18.1M
Certified to comply with ANSI A112.18.1M
Plumbers' Putty or Caulking
B
S P O U T B A S E
7
4
5
6
8
M965788 Rev. 1.0 (11/18)
7
9
3
2