Stryker 4100-000-000 Instrucciones De Uso página 6

4100-005-700 Rev-N
1/4" Keyed Chuck (REF 4100-131-000)
Handles wires, pins, and drill bits up to 1/4 in.
(6.4 mm) diameter.
5/32" Drill (REF 4100-132-000)
Handles wires, pins, and drill bits up to 5/32 in.
(4 mm) diameter.
Wire Collet (REF 4100-062-000)
This collet holds K-wires having diameters from 0.028 – 0.071 in.
(0.7 – 1.8 mm).
Pin Collet (REF 4100-125-000)
This collet holds pins having diameters from 0.078 – 0.125 in.
(2.0 – 3.2 mm).
To operate the Cordless Driver with the Wire Collet or Pin Collets:
1. Load the wire or pin into the nose of the collet or back cap of the handpiece.
2. Move the safety switch out of the safety position.
3. Squeeze the wire advance control lever against the instrument to hold the wire at the desired length
exposed from the distal end of the instrument.
4. Hold the wire or pin against the bone, then depress the trigger to drive the wire or pin.
5. To obtain additional wire length for inserting, release the wire advance control and pull back the
instrument. Then, squeeze the wire advance control lever and the trigger to drive more wire.
6. To withdraw threaded pins, squeeze the wire advance control lever and then depress the reverse trigger.
www.stryker.com
1/4" Reamer (REF 4100-231-000)
Handles wires, pins, and drill bits up to 1/4 in.
(6.4 mm) diameter with low speed and high torque.
Chuck style accessories are supplied with a
chuck key.
EN
5