Multipick LockForce Manual página 5

Option 2:
UK
Using the Lockforce when the cylinder
does not jut out
When the cylinder you want to break off/
pull does not jut out the use of a special
pull-screw is necessary. Select the approp-
riate pull screw depending on the width of
the keyway and screw it in above the pins.
The screw should be driven in as a far as
possible while still allowing to connect the
Lockforce. There now exist two different
methods you can apply:
1.
Pulling the plug - Before connecting the
Lockforce to the screw you have to eit-
her insert the pulling ring into the head of
the tool (for profile cylinders) or place the
base plate around the cylinder (round cy-
linders). After connecting the Lockforce to
the screw, carefully tighten the the pulling
mechanism pulling out the core of the cy-
linder completely through the hole of either
ring or base plate. This does not require a
lot of force. If the mechanism tightens with
difficulty only, please check that the plug is
not blocked by ring/base plate. After that
you can unlock by using a screw driver to
move the coupling. The advantage of this
method is that the exterior of the cylinder
will remain completely undamaged. This is
absolutely necesary for multi-point bolts or
half cylinders. Other methods may cause
serious damages at the locking mecha-
nism. This method of pullting the plug will
also work on cylinders containing hardened
pins/tumblers!
Multipick-Service
®