Flex PD 2G 18.0 Instrucciones De Funcionamiento Originales página 21

PD 2G / DD 2G / ID 1/4"
Direction preselection
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
 Move the direction preselector switch to
the required position:
– Left:: counterclockwise (remove screws,
release screws)
– Right: clockwise
(drill, insert screws, tighten down
screws)
– Middle: switch-on interlock
(tool change, when working on the
power tool)
Operating mode (PD 2G 18.0 only)
CAUTION!
Change the operating mode only when the
power tool is stopped.
 Move the operating mode turning dial to
the required position.
: Drilling
: Screwing
: Impact drilling
Torque preselection (PD 2G 18.0/
DD 2G 18.0)
CAUTION!
Change the torque only when the power tool
is stopped.
 Move the torque setting turning dial to the
required position.
DD 2G 18.0:
1-20: Screwing
: Drilling
NOTE
The safety clutch is deactivated in the
Drilling setting .
PD 2G 18.0:
Speed preselection
(PD 2G 18.0/DD 2G 18.0)
CAUTION!
Change the speed only when the power tool
is stopped.
21