Flex PD 2G 18.0 Instrucciones De Funcionamiento Originales página 23

PD 2G / DD 2G / ID 1/4"
3. Set torque preselection to the required
setting.
4. Set speed to the required setting.
5. Set the required direction of rotation.
6. Hold the power tool with one hand on
the handle and assume the working
position.
7. Switch on the power tool.
At the end of work:
8. Release the trigger switch.
9. Move the direction preselector switch
(2) to the middle position.
Charger
1 Insertion slot for battery
2 Contacts
3 Ventilation slots
4 Operating state display
5 Power cord with mains plug
The CA 10.8/18.0 charger is designed to
charge FLEX batteries of the following types
– AP 10.8 (2.5 Ah),
– AP 18.0 (2.5 Ah),
– AP 10.8 (5.0 Ah) and
– AP 18.0 (5.0 Ah).
Tips for a long battery service life
CAUTION!
Never charge batteries at temperatures
–
below 0 °C or above 55 °C.
Do not charge batteries in environments
–
with high air humidity or ambient
temperature.
Do not cover batteries and the charger
–
during the charging process.
Pull out the charger mains plug at the
–
end of the charging process.
Battery and charger heat up during the
charging process. This is perfectly normal!
Lithium-ion batteries do not exhibit the
established "memory effect". Nevertheless,
a battery should be completely discharged
before charging and the charging process
should always be fully completed.
If batteries are not used for an extended
period of time, store them partially charged
in a cool place.
Charging process
CAUTION!
Insert only original batteries in the supplied
charger.
 Insert the charger mains plug.
The display backlighting lights up green
for 2 seconds and then goes out again.
OK is displayed.
23