Surface-Grinding The Electrode Tip; Cutting The Electrodes To Length; Switching Off The Esg Plus - Orbitalum 790 052 773 Traducción Del Manual De Instrucciones Original

ENGLISH
Operation
7.2.2 Surface-grinding the electrode
tip
Precision ground point. Although able to grind flat land on tip.
X Insert the electrode (1.0/1.6/2.0/2.4/3.2 or 4.0 mm)
through the openings at the front end onto the grinding
wheel and square the electrode tip.
7.2.3

cutting the electrodes to length

In order for the electrode rods to be used for e.g. orbital
welding, or for manual welding, they have to be cut to length.
1. Insert the electrode into the lateral slot.
2. The electrode is cut evenly by turning the electrode
slowly (optional cutting device for 12, 13, 15 and 17 mm,
see chap. 3.1.2, p. 25).
7.3

Switching off the ESG Plus

X Press the ON/OFF switch (1).
The ESG Plus stops.
30
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
ESG PLUS, ESG PLUS²
[REV. 20200117] OW_ESG_BA_790052773_00__INH-02_EN