Kenmore 62342 Manual De Uso página 5

CONTROL PANEL AND FEATURES
Medium CYCLE SIGNAL
Off On .ow Casual High Off On
Wrinkle Guard Dry Temp Push to Sfart
Not all features and options are available on all models.
Appearance may vary.
_]_ DRYER CYCLE KNOB O
Turn the knob to select a cycle for your laundry load.
See "Cycle Guide" for detailed descriptions of cycles.
Timed Dry
Will run the dryer for the specified time on the control.
On models with a selectable temperature knob, you may
choose a setting based on the fabrics in your load. Drying
time and temperature will depend on your dryer model.
Auto Moisture
SenslngTM
Auto Dry cycles with Auto Moisture Sensing
TM
give the best
drying in the shortest time. Drying time will vary based on
fabric type, load size, and dryness setting.
Air Only
Use the Air Only setting to dry foam, rubber, plastic,
or heat-sensitive fabrics.
Wrinkle Guard
TM
option (on some models)
When you are unable to remove a load of clothes from the
dryer as soon as it stops, wrinkles can form. The WRINKLE
GUARD
TM
option periodically tumbles, rearranges, and fluffs
the load to help keep wrinkles from forming.
[] Get up to 40 minutes of heat-free, periodic tumbling at
the end of a cycle. Turn the WRINKLE GUARD
TM
knob to
select ON or OFF at any time before the cycle has ended.
O
Dry Temp (on some models)
Select a drying temperature based on the fabrics in
your load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the higher
setting. See "Cycle Guide."
Cycle Signal/PUSH TO START
The Cycle Signal produces an audible sound when the drying
cycle is finished. On some models, this knob is combined with
the PUSH to START button. Promptly removing clothes at the
end of the cycle reduces wrinkling.
Turn the CYCLE SIGNAL knob to select the desired setting
(On or Off). With combined buttons, press and hold the
CYCLE SIGNAL/PUSH to START button to start the dryer.
On models without the cycle signal, press the PUSH to START
button to start the dryer.
NOTE: When the Wrinkle Guard
TM
setting is selected and
the Cycle Signal is on, the tone will sound every 5 minutes
until the clothes are removed, or the Wrinkle Guard
TM
setting ends.