Dryer Care; Important - Kenmore 62342 Manual De Uso

Ocultar thumbs Ver también para 62342:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DRYER CARE
g the dryer
location
Explosion Hazard
Keep flammable
materials
and vapors,
such as
gasoline,
away from
dryer.
Place dryer
at least !8 inches
(460 turn) above
the floor
for a garage
installation.
Failure
to do so can result
in death,
explosion,
or fire.
fCleaning
the dryer
interior
To clean dryer drum
1. Apply a liquid, nonflammable
household cleaner
to the
stained
area of the drum and rub with a soft cloth until
stain is removed.
2. Wipe
drum thoroughly
with a damp cloth.
3. Tumble a load of clean cloths or towels to dry the drum.
NOTE: Garments
that contain loose dyes, such as denim
blue
jeans or brightly colored
cotton items, may discolor
the dryer
interior. These stains are not harmful to your dryer and will
not stain future loads of clothes.
Dry these items inside out
to avoid drum staining.
Removing
accumulated
lint
From inside the Dryer Cabinet
Lint should
be removed
every 2 years, or more often,
depending
on dryer
usage. Cleaning
should
be done
by a qualified
servicer.
From the Exhaust Vent
Lint should
be removed
every 2 years_ or more often_
depending
on dryer
usage.
Cleaning
the lint screen
Every load cleanlng
The lint screen is located
in the dryer. A screen blocked
by lint can increase
drying
time.
To clean:
1. Pull the lint screen out of its holder.
Roll lint off:
the screen with your fingers.
Do not rinse or wash
screen to remove
lint.
2. Push the lint screen firmly
back into place.
iMPORTANT:
[]
Do not run the dryer
with the lint screen loose, damaged,
blocked,
or missing.
Doing
so can cause overheating
and
damage
to both the dryer
and fabrics.
[]
If lint fails off: the screen into the dryer during
removal_
check
the exhaust
hood and remove
the lint. See
"Venting
Requirements"
in the Installation
Instructions.
[]
Clean space where
lint screen is located
monthly.
Using
a vacuum_
gently
remove
any lint that has accumulated
outside
of the lint screen.
As needed cleaning
Laundry detergent
and fabric
softener
residue can build up
on the lint screen. This buildup
can cause longer drying
times
for your clothes,
or cause the dryer
to stop before
your load
is completely
dry. The screen is probably
clogged
if Nnt falls
off: while the screen is in the dryer.
Clean the lint screen with a nylon brush every 6 months,
or more frequently,
if it becomes
clogged
due to a residue
buildup.
To
wash:
1. Roll lint off: the screen with your fingers.
2. Wet
both
sides of lint screen with hot water.
3. Wet
a nylon brush with
hot water
and liquid
detergent.
Scrub lint screen with the brush to remove
residue
buildup.
4. Rinse screen with hot water.
5. Thoroughly
dry lint screen with a clean towel.
Reinstall
screen in dryer.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

72342C62442C72442

Tabla de contenido