OHAUS Scout SPX Serie Manual De Instrucciones página 15

TM
SCOUT SERIES BALANCES - SPX EN-13
Exponent
Set the factor multiplier.
-3
-3 = divide the Factor by 1000 (1x10 )
-2
-2 = divide the Factor by 100 (1x10 )
-1
-1 = divide the Factor by 10 (1x10 )
0
0 = multiply the Factor by 1 (1x10 )
1
1 = multiply the Factor by 10 (1x10 )
2
2 = multiply the Factor by 100 (1x10 )
3
3 = multiply the Factor by 1000 (1x10 )
Least Significant Digit
Set the graduation.
Settings of 0.5, 1, 2, 5, 10, 100 are available.
Note: Custom Unit is locked at Off position when the Security Switch is set to the locked position.
Follow below instructions below to enter the unit menu to set the Custom Unit.
Press and hold Menu until [mMeNU] is displayed. When the button is released, the display will
show [C.A.L]. Press No through the succeeding menu items: [C.A.L], [SEtUP], [mModE] until [Unit] is
displayed.
1. When [Unit] is displayed, press Yes.
2. [rESEt] will be displayed. Press No, [Unit ] will be displayed.
g
c
3. Press No to toggle through active units until [Unit ] is displayed.
c
4. Press Yes, [On ] will be displayed, then press Yes.
5. [Factor] is displayed. Press Yes to view the default Factor. Press Yes to accept or No to edit
the "factor multiplier". The stored value is then displayed with the first digit highlighted
[1.0000000]. Repeatedly press No until the desired number appears. Press Yes to accept and
highlight the next digit. Repeat until all the digits are correct. Press Yes to accept the "Factor"
value.
6. [EPt] is displayed. Repeat the same procedure as in step 5 to accept or edit the "Exponent"
value. Press Yes to accept the "Exponent" value.
7. [LSd] is displayed. Repeat the same procedure as in step 5 to accept or edit the "Least
Significant Digit" value. Press the Yes key to accept the graduation value, [End] is displayed.
8. When [End] is displayed, press Exit to exit to weighing mode.