Getting Started - Jays F5TW01 Manual Del Usuario

EN English

Getting started

Power on/off and pairing
To power on, place the earpieces in the charging case then take
them out of the charging case. The LED on both earpieces will flash
in white.
The LED will flash in red and white as the earphones enter pairing
mode automatically. To pair, go to Bluetooth
device and select "JAYS f-Five True Wireless". The white and red
flashing LED on the earpiece will turn off upon a successful
connection and change to a slow white flashing every fifth second. If
the pairing fails, the earpieces will stay in pairing mode as the LED
flash in red and white for a few minutes until they finally power off.
To power off, place the earpieces in the charging case and they will
turn off automatically. If the Bluetooth
off, the earphones will turn off automatically.
Reconnecting and additional pairing
If the earpieces recognize a nearby previously paired Bluetooth
device when taken out of the charging case, they will pair
automatically to that certain device as the LED changes to a slow
white flashing every fifth second.
Charging the earpieces
Place the earpieces in the charging case, the charging will begin
automatically. The charging is indicated by the red LED flashing on
each earpiece. Left and right LED on the charging case will also be lit
when charging corresponding earpiece. When the red and white
LEDs turn off, the earphones are fully charged.
Charging the case
Charge the case by connecting the included cable to the bottom of
the case and any certified USB power output. A full 100% charge will
take around 2.5 hours (depending on temperature and charger).
Battery status of the earpieces
When the LED flash in red every five minutes, the battery level is
running low. The battery level will also be displayed at the top of the
screen of the paired device (may not apply to all devices). When the
earpieces are placed in the case, the LEDs on the case will first
display the battery level of the case, after that - the left and right
LEDs will flash if the corresponding earpiece needs charging.
Battery status of the case
When the earpieces are placed in the case, the LEDs on the case will
display the battery level of the case. One light, 25% battery. Two
lights, 50% battery. Three lights, 75% battery. Four lights 100%
battery.
® settings on your
®
on the paired device turns
®
Troubleshooting
Problem pairing and connecting
• Make sure the earphones are not connected to another device.
• Disable and enable Bluetooth
• Move the earphones closer to the device or alter their positions
to avoid Bluetooth ® interference.
• Verify no other wireless equipment interfere with your earphones
Bluetooth ® signal.
• If the earpieces does not pair with eachother, place the earpieces
in the charging case, then take them out both at the same time.
Problem with sound transmission
Move the streaming device to another position. Your body, distance,
differen materials and other wireless equipment can interfere with the
wireless signal between your device and earphone.
FAQ and quickstart guide
Visit jaysheadphones.com for more instructions and help on this
product.
® on your device.