Broan Best Instrucciones de montaje y utilización Manual Del Usuario página 8

OPERATION
Controls
The light switch turns the halogen lights on
and off.
The blower on/off switch turns the blower on
to its lowest running speed. The blower must
be turned on using this switch. Turn the blower
off by pressing this switch a second time.
The blower medium speed switch changes
the blower speed to medium. This switch works
only if the blower is already running at low or
high speed.
The blower high speed switch changes the
blower speed to high. This switch works only if
the blower is already running at low or medium
speed.
The pilot lamp lights up whenever the blower is on.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original
setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned
OFF. When this occurs, it is impossible to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical panel.
HALOGEN BULBS
This range hood requires two halogen bulbs
(Type T4, 12V, 20W).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Open the light lens by grasping the tab on
the lens and rotating lens downward.
2. Remove the bulb by pulling sideward (Do
not rotate). CAUTION: BULB MAY BE HOT!
3. Do not touch replacement bulb with bare
hands! Push bulb securely into lamp socket
and snap lens closed.
IN CASE THE NEW BULB DOES NOT LIGHT,
CONTACT "BROAN TECHNICAL SUPPORT" AT
800-637-1453.
BLOWER HIGH SPEED
BLOWER MEDIUM SPEED
BLOWER ON/OFF
LIGHT LENS
- 8 -
PILOT LAMP
SWITCH
LIGHT SWITCH
TAB