Setup (Windows Environment) - Kingston DataTraveler Locker+ G2 Manual De Instrucciones

Setup (Windows Environment)

1. Insert the DTL+ G2 into an available USB port on
your notebook or desktop and wait for Windows
to detect it.
• Windows XP users will receive a 'Found New
Hardware' notification as seen in
• Windows Vista/7 users will receive a device
driver notification as seen in
Once the new hardware detection is complete,
Windows will begin the initialization process.
• If the Windows autorun function is enabled,
you can skip the next step and go to page 5 –
Device Initialization.
• If the Windows autorun function is disabled, as
it is in Windows 7 by default, you may see an
AutoPlay window similar to the one in
.
2.3
2. Select the option '
If Windows does not AutoPlay, simply browse to the
CD-ROM partition (
the DTLplus_Launcher program. This will also start
the initialization process.
Figure 2.4 – DTL+ G2 Contents
Document No. 48002017-001.A03
Figure 2.2
Run DTLplus_Launcher.exe
) and manually execute
Figure 2.4
DataTraveler
.
Figure 2.1
.
Figure 2.2 – Device Driver Installation
Figure
'.
(
Note: Menu options in the AutoPlay
window may vary depending on what
programs are currently installed on
your computer. If enabled, AutoRun
will start the initialization process
automatically.
®
Locker+ G2
Figure 2.1 – Found New Hardware
(Windows XP)
(Windows Vista/7)
Figure 2.3 – AutoPlay Window
(Windows Vista/7)
)
Page 4 of 22