Descargar Imprimir esta página

Steelcase Groupwork Serie Manual De Instrucciones página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

®
4.
Remove shoulder screw and nut from each leg. Discard screws,
and retain nuts for use in step 5.
5.
Insert new shoulder screw (5a) and tap all the way in with mallet.
Secure nut (5b) to shoulder screw and torque screw to 150±5 in-lbs.
NOTE: New shoulder screw is slightly longer than the old one. See
illustration below for actual dimensions.
NOTE: When securing nut, be careful not to put pressure on the control
lever cable end. Too much pressure could cause cable connector to break.
6.
Verify that plate and control lever are in correct location using
screw locations shown at right.
RISK OF INJURY. The correct location of leg
mounting plates and control levers is critical to
the safe functioning of the table.
NUT - REUSE
NUT
5b
OLD SHOULDER
SCREW - DISCARD
4
NEW SHOULDER SCREW
5a
SCREW LOCATIONS
A
B
6
B
4.125
3.875
C
D
E
Wksf
A
B
Depth
24"
11.23
7.2
30"
8.375
10.2
1.44"
2.4"
OLD SHOULDER SCREW - DISCARD
1.57"
2.5"
NEW SHOULDER SCREW
SHOULDER SCREW
DIMENSIONS
A
B
Wksf
Depth
B
4.125
3.875
C
D
E
C
D
E
8.73
19.0
20.0
5.875
14.75
15.75
Page 2 of 24
1051162001 Rev G

Publicidad

loading