Steelcase Groupwork Serie Manual De Instrucciones página 5

®
12.
Visually line up single hole and 45° edges in clamp assembly,
with hole and 45° bend in linkage bar (12a). With threaded clamp plate
facing side edge of table, slide clamp assembly over front leg tube (12b).
Rotate clamp assembly 90° (12c) so that threaded clamp plate faces
rear edge of table (12d).
NOTE: Damage to leg finish could occur if clamp assembly rubs
against leg during installation.
12d
THREADED
CLAMP PLATE
REAR
12c
o
45 CLAMP EDGES ALIGNED WITH
o
45 BEND IN LINKAGE BAR
CLAMP
LY
ASSEMB
12a
HOLE
LINKAGE BAR
12b
Page 5 of 24
1051162001 Rev G