Basic Operation; Checking Part Names And Functions; Inserting And Ejecting A Disc; Connection - Pioneer XDV-10 Manual De Instrucciones

Basic operation

Checking part names and
functions
1
1
button
2 Disc-loading slot

Inserting and ejecting a disc

CAUTION
Do not insert anything other than a disc into the disc-loading
slot.
Inserting a disc
1 Insert a disc into the disc-loading slot.
Ejecting a disc
1 Press the button.
2 Remove the disc, and press the
4

Connection

Precautions

CAUTION
 Do not directly connect the yellow lead of this product
to the vehicle battery. If the lead is directly connected
2
to the battery, engine vibration may eventually cause
the insulation to fail at the point where the wire
passes from the passenger compartment into the
engine compartment. If the yellow lead's insulation
tears as a result of contact with metal parts, short-
circuiting can occur, resulting in considerable danger.
 Make sure that the cables and wires will not interfere
with or become caught in any of the vehicle's moving
parts, especially the steering wheel, gearstick,
handbrake, sliding seat tracks, doors, or any of the
vehicle's controls.
 Do not route wires where they will be exposed to
high temperatures. If the insulation heats up, wires
may become damaged, resulting in a short circuit or
malfunction and permanent damage to the product.
 Do not shorten any leads. If you do, the protection
circuit (fuse holder, fuse resistor or filter, etc.) may
fail to work properly.
 Never feed power to other electronic products by
cutting the insulation of the power supply lead of
this product and tapping into the lead. The current
capacity of the lead will be exceeded, causing
overheating.

Before installing this product

button.
 Use this product with a 12-volt battery and negative ground-
ing only. Failure to do so may result in a fire or malfunction.
 To avoid shorts in the electrical system, be sure to discon-
nect the (–) battery cable before installation.

To prevent damage

 The black lead is earth. Please earth this lead separately
from the earth of high-current products such as power
amps. Do not earth more than one product together with
the earth from another product. For example, you must
separately earth any amp unit away from the earth of this
product. Connecting grounds together can cause a fire
and/or damage the products if their grounds became
detached.
 This product cannot be installed in a vehicle without ACC
(accessory) position on the ignition switch.
ACC position No ACC position

Parts supplied

RGB cable This product