Built-In Timer; Maintenance; Declaration Of Compliance - Espa SilenPlus Manual De Instrucciones

• Configuring Backwash Plus.
The maximum and minimum speeds are set, al- The maximum and minimum speeds are set, a
ways maintaining a differential of 20 Hz between a differential of 20 Hz between
them
· Minimum = 1,600/2,320 RPM (20/40 Hz), [= fs] Minimum = 1,600/2,320 RPM (20/40 Hz), [= fs]
· Maximum = 1,740/2,900 RPM (30/50 Hz) Maximum = 1,740/2,900 RPM (30/50 Hz)
• Configuring the Mixed Cycle (Manual only)
Configuring the Mixed Cycle (Manual only)
The factory setting is 2,320 RPM (40 Hz) The factory setting is 2,320 RPM (40 Hz)
· Minimum = 1,600 RPM (20 Hz)
· Maximum = 2,900 RPM (50 Hz), [= fs]
If M and F are not pressed for 5 seconds the new va If M and F are not pressed for 5 seconds the new val-
ues are stored and the configuration mode is ues are stored and the configuration mode is
deactivated.
SilenPlus can also be entirely configured using can also be entirely configured using
the EspaEvopool application.

7. BUILT-IN TIMER

The SilenPlus pump has an internal clock that can
operate as a start and stop timer, making external operate as a start and stop timer, making external
programming unnecessary.
With this function, SilenPlus can operate entirely ind
pendently.
WARNING: the programming and maintenance WARNING: the programming and maintenance
of the timer is only possible using an Android of the timer is only possible using an Android
device with Bluetooth connectivity and the with Bluetooth connectivity and the
EspaEvopool app, available from app, available from
7.1 Activating the timer.
DANGER.Electrocution risk.
Never open the SilenPlus cover without turning
the power supply off at least 5 minutes the power supply off at least 5 minutes before
hand.
• Lift the SilenPlus cover by loosening the 4 screws.
cover by loosening the 4 screws.
(See figure 5)
• Activate the Timer using the mini-switch, moving it
to the "ON" position.
• Replace the cover and fix it with the 4 screws.
Replace the cover and fix it with the 4 screws.
Torque: 0.5 Nm.
7.2. Time setting.
Link SilenPlus with the external device using Bluetooth, th the external device using Bluetooth,
following the instructions on the device. following the instructions on the device.
Run the EspaEvopool app and follow its indications. app and follow its indications.
0 Hz), [= fs]
l clock that can
can operate entirely inde-
www.espa.com
cover without turning
switch, moving it

8. MAINTENANCE

ControlSystem:
If ControlSystem is not communicating with is not communicating with SilenPlus it
may be necessary to replace the battery. may be necessary to replace the batt
Proceed as in section 4.2.
It is a 1.5 V, CR2450 type battery. It is a 1.5 V, CR2450 type battery.
SilenPlus:
Our SilenPlus equipment is maintenance free. equipment is maintenance free.
Clean the equipment with a damp cloth and without Clean the equipment with a damp cloth and without
using aggressive products.
In freezing weather, take the precaution of em In freezing weather, take the precaution of emp-
tying the pipes.
If the equipment is going to be inactive for a If the equipment is going to be inactive for a
long time, you are recommended to dismantle it long time, you are recommended to dismantle it
and keep it in a dry, well-ventilated place. and keep it in a dry, well
WARNING: in case of a breakdown, the equip- WARNING: in case of a breakdown, the equi
ment must only be touched by an authorised ment must only be touched by an authorised
service technician.
The list of official technical services can be found at The list of official technical services can be found at
www.espa.com.
When the time comes to throw the product away, it When the time comes to throw the product away, it
does not contain any toxic or polluting material. The does not contain any toxic or polluting material. The
main components are duly identified so you can di main components are duly identified so you can dis-
pose of them selectively.

9. DECLARATION OF COMPLIANCE

CLARATION OF COMPLIANCE
We declare, under our own responsibility, that the We declare, under our own responsibility, that the
products in this manual meet the following Community products in this manual meet the following Community
directives and technical regulations: directives and technical regulations:
- Directive 2004/108/EC (EMC) Directive 2004/108/EC (EMC)
· Regulations EN 61000-6
- Directive 2006/95/EC (Low Voltage)
· Regulation EN 60730-1 and EN 60730
Pere Tubert (Technical Manager) Pere Tubert (Technical Manager)
ESPA 2025, SL ESPA 2025, SL
Ctra.deMieres, s/n – 17820 Banyoles Ctra.deMieres, s/n
Girona -
11
EN
6-1 and EN 61000-6-3
(Low Voltage)
1 and EN 60730-2-6
- Spain