Klimatronic HEAT FLOW 2000 Manual Del Usuario página 15

OPERATION OF THE HEATER
NOTE: - It is normal when the heaters are turned on for the first time or when they are
turned on after having not been used for a long period of time the heaters may emit some
smell and fumes. This will disappear when the heater has been on a short while.
*
M IN MAX
TIMER (ONLY HEAT FLOW 2020 and 2050)
A. SLIDE SWITCH
B. SEGMENTS
C. POINTER
HEAT FLOW 2000 Convector heater with thermostat
Choose a suitable location for the heater, taking into account the safety instructions
above.
Insert the plug of the heater into a suitable socket. Turn the thermostat knob fully in a
clockwise direction to the maximum setting. Turn on the heating elements by means of
the rocker switches on the side panel. When the heating elements are on the switches
will illuminate. For maximum heat output both switches should be on.
When the desired room temperature has been reached, the thermostat knob should be
turned slowly anti-clockwise until the thermostat is heard to click off and the lights on
the element switches are seen to go out.
temperature in the room at the set temperature by switching on and off automatically.
In its minimum (fully anti-clockwise) position, the thermostat provides a frost guard
position. In this position (depending on the size of the room) the heater will maintain the
temperature above freezing.
CONTROL PANEL
1. HEATER SWITCHES
2. FAN SWITCH
(NOT FITTED ON HEAT FLOW 2020 and 2050)
3. THERMOSTAT KNOB
After this the heater will keep the air