Klimatronic HEAT FLOW 2000 Manual Del Usuario página 16

HEAT FLOW 2010 Convector heater with thermostat and timer
All the above instructions for model HEAT FLOW 2000 (above) also apply to model
HEAT FLOW 2010.
This model is also fitted with a 24hr timer which has 96 segments around its
circumference, each segment being equivalent to 15 minutes of time. With the aid of
this timer it is possible to preset the time and duration of the period(s) that it is desired
the heater will operate, in any 24hr period.
Timer Operation
The centre of the timer has a 3 position slide switch.
In the central position (denoted by the clock symbol) the timer will switch the heater on
and off at times set by the segments, (see setting the timer, below).
The position denoted by the "I", is a timer override position. The timer will continue to
run but power will be fed continuously to the heater. This enables the heater to be on all
the time if required.
In the position denoted by the "O", the timer continues to run but no power is fed to the
heater.
Setting the Timer
Ensure the slide switch on the timer is at the mid position next to the clock symbol.
Rotate the outer ring of the timer in a clockwise direction until the current time is lined up
with the arrow pointer, i.e. if the time the timer is being set is 8 pm, rotate the outer ring
until the number 20 is in line with the arrow pointer.
Set the time the heater is required to run by pulling the segments around the outer ring
forward appropriate to the running period(s) required.
When set, the heater will operate each day during the times programmed. Note, the
heater must always be plugged into a power socket, the element switches must be in the
on position and the thermostat must be suitably set to ensure the heater will come on.
If the heater is required to run continuously the slide switch on the timer should be set to
the "I" position.
If it is subsequently required to revert back to timer operation, the slide switch on the
timer should be set to the central (clock) position.
Note: - When using in timer mode, due consideration should be given to the fact that the
heater may come on whilst unattended.
HEAT FLOW 2020 Convector heater with thermostat and fan
All the above instructions for model HEAT FLOW 2000 (above) also apply to model
HEAT FLOW 2020.
Model HEAT FLOW 2020 also incorporates an internal fan, which can be switched on
independently of the heating elements.
Fan Operation: -This is operated by means of the switch with the fan symbol along side it.
The fan will only operate with the thermostat in the "on" position and can be used
when the heating elements are "on" to blow warm air into the room. In warm conditions
the fan can be used with the heating elements "off" to blow cool air into the room.
HEAT FLOW 2050 Convector heater with thermostat, timer and fan
All the above instructions for models HEAT FLOW 2000 and HEAT FLOW 2010 and
HEAT FLOW 2020 (above) also apply to model HEAT FLOW 2050.