WALL MOUNTING
The heater is supplied with 4 off each fixing brackets, screws and plastic wall plugs to
enable it to be mounted onto a wall if required. If it is decided to mount the heater on the
wall, the feet should not be fitted. The position must be chosen carefully. It must not be in
front of or below a power socket. It must not be below a shelf, curtains or any other
obstruction. Also refer to the safety instructions overleaf.
Having decided on the location of the heater it is necessary to drill 2 fixing holes 8mm
diameter by 43mm deep at 486mm centers on a horizontal line at a minimum height of
400mm from the floor.
if any skirting boards are present, the fixing holes must be a minimum of 400mm above
the top edge of the skirting board. Using the plastic plugs and fixing screws provided,
attach 2 of the fixing brackets to the wall. The other pair of fixing brackets must be
attached to the base of the heater using the feet retaining screws so that the brackets
project out at the rear of the heater and space the bottom edge away from the wall.
If required, these brackets may also be secured to the wall using the remaining fixing
screws and plastic wall plugs. If this option is chosen it is suggested that the heater is
hung on the upper brackets and the hole positions for the lower brackets is then marked
on the wall, prior to drilling the holes for attachment purposes.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time it should be protected from dust and
stored in a clean dry place.
In case of complaint
You can claim the device within 24 months from date of purchase (receipt).
A free replacement or repair will be excluded from prior improper product handling.
Defects in wear parts, consumables, as well as cleaning, maintenance or
replacement of said parts are therefore with costs.
If you want to make a complaint, please bring the entire device in its original
packaging and with proof of purchase to your dealer. For a timely and convenient
service register, visit our website www.suntec-wellness.de and learn more.
Without a proof of purchase, generally there will be no repair or replacement.
In the event that the complaint case is analogous to our terms of service, all defects
of the device or its accessories due to material or manufacturing defects will be
eliminated by repair or, at our discretion, replacing the unit.
The damage of accessories does not automatically lead to a free exchange of the
whole device. In these cases, please contact your dealer. Glass breakage or
breakage of plastic parts are always to charge.
The dealer or repair service can perform the repair after the expiration of warranty
against charge.
Allowance must be made for any floor coverings, carpet etc and