Kohler Pillows K-7943 Guia De Instalacion página 5

3. Install the Wall Anchor(s)
Hold the toggle anchor flat alongside the plastic straps and slide it
through the previously drilled hole.
With one hand, pull the looped end straight out (do not pull at an
angle) so that the toggle anchor rests flush behind the wall.
Slide the clip along the straps with your other hand until the flange
of the clip is flush with the wall.
Place your thumb between the plastic straps. Wiggle the straps
side-to-side until they snap off at the wall.
Insert the enclosed bolt through the wall plate and tighten until it is
flush with the wall.
Minimum clearance behind the wall is 1–7/8" (4.8cm).
4. Install the Wall Bracket
Insert the mounting screws through the wall bracket mounting holes
and into the slip fitting.
Thread the screws into the metal channel and tighten with a Phillips
screwdriver.
Kohler Co. 5 1020815-2-A