Flex CHE 5-45 SDS-max Instrucciones De Funcionamiento Originales página 16

Inserting the tools
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
`^rqflk>
rëÉÇ=áåëÉêíáçå=íççäë=ã~ó=ÄÉÅçãÉ=ÜçíK=
tÉ~ê éêçíÉÅíáîÉ=ÖäçîÉë>
 Clean and lightly grease the shaft
of the insertion tool.
 Check dust cap.
– Clean dirty cap.
– Replace defective dust cap.
 Insert insertion tool and turn until it locks.
 Check lock by pulling on the insertion tool.
Removing the tools
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
`^rqflk>
rëÉÇ=áåëÉêíáçå=íççäë=ã~ó=ÄÉÅçãÉ=ÜçíK=
tÉ~ê éêçíÉÅíáîÉ=ÖäçîÉë>
 Pull locking sleeve backwards (1.).
 Remove insertion tool (2.).
16
Attaching the depth stop
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
 Loosen knurled screw on the auxiliary
handle.
 Push in depth stop.
 Set depth stop to the required drilling
depth.
 Retighten knurled screw.
Speed and impact rate preselection
 Set thumb wheel to the required value.
Setting
Speed (min
1 235
2 265
3 320
4 380
5 440
6 500
CHE 5–45 SDS-max
-1 Impact number
)
-1
(min )
1350
1520
1840
2180
2530
2870