Setting Operating Mode - Flex CHE 5-45 SDS-max Instrucciones De Funcionamiento Originales

CHE 5–45 SDS-max

Setting operating mode

`^rqflk>=
aç=åçí=ÅÜ~åÖÉ=çéÉê~íáåÖ=ãçÇÉ=ìåíáä=íÜÉ=
ÉäÉÅíêáÅ=éçïÉê=íççä=áë=~í=~=ëí~åÇëíáääK
Setting rotary knob to the required operating
mode:
Hammer drilling
Setting the chisel position
(see below)
Chiselling
Setting the chisel position
The chisel can be adjusted in 16 positions
(moved 22.5° in each case).
 Move rotary knob for operating
mode to the
 Turn rotary ring for chisel setting until
the chisel is at the required angle.
 Move rotary knob for operating mode
to the symbol.
symbol.
Switching on the power tool
 Press and hold down the switch.
Switch off the machine:
 Release the switch.
Safety clutch
`^rqflk>=
fÑ=íÜÉ=ë~ÑÉíó=ÅäìíÅÜ=íêáéëI=ëïáíÅÜ=çÑÑ=íÜÉ=éçïÉê=
íççä=áããÉÇá~íÉäó>
The safety clutch disconnects the motor from
the tool if a preset torque limit value is exceeded.
The insertion tool stops. As a result, the motor
and gears are protected from damage.
Operating instructions
`^rqflk>=
fÑ=íÜÉ=êÉÇ=iba=
çéÉê~íáçåI=ëïáíÅÜ=çÑÑ=íÜÉ=éçïÉê=íççä=áããÉÇá~J
íÉäó=~åÇ=éìää=çìí=íÜÉ=ã~áåë=éäìÖK=e~îÉ=ÉäÉÅíêáÅ=
éçïÉê=íççä=êÉé~áêÉÇ=Äó=ÅìëíçãÉê=ëÉêîáÅÉK
Hammer drilling
1. Move rotary knob for operating
mode to the
2. Insert drill bit.
3. Swivel the auxiliary handle into the required
position.
4. Set speed to the required value.
5. Insert mains plug.
The green LED
readiness) lights up.
EëÉêîáÅÉF=äáÖÜíë=ìé=ÇìêáåÖ=
symbol.
(operational
17