Operating Manual - WELDY booster EX2 Instrucciones De Funcionamiento

Operating Manual

EN
Please read operating instructions carefully before use
and keep for further reference.
Weldy booster EX2 / EX3
Handheld extruder
Application
Welding of PE and PP plastics in the following areas of application:
• container engineering
• plastic fabrication
10
(Translation of the Original User Manual)
• pipeline construction
• plastic Repairs
Warning
Hazardous voltage, danger to life:
When opening the device, live parts are exposed. Pull the power plug from the outlet
before opening the device. Prior to commissioning, check the power cord, the plug,
and the extension cable for electrical and mechanical damage.
Danger of fire and explosion:
If the device is used improperly (e.g., due to the material overheating), there is a
danger of fire and explosion, particularly in the vicinity of flammable materials and
explosive gases.
Risk of burning:
Do not touch exposed metal parts or molten material while hot. Allow the device to
cool down first after operation or before mechanical settings. Never point the hot air
flow at people or animals.
Caution
The local supply voltage must match the nominal voltage specified on the de-
120
vice.In the event of a power failure, the switch of the hot-air blower and the drive
230
must be switched off (release locking device).
FI
To protect people on construction sites, we strongly recommend connecting
the device to a residual current device (RCD).
The device must only be operated under supervision, as heat can lead to
ignition of flammable materials. The device must be operated exclusively by
trained specialists or under their supervision. Children must not use this
device.
The device must be protected against humidity and moisture.
Repairs may only be carried out by local Weldy partners. Only original accessories
and spare parts from Weldy may be used for repair.