Set Up Blender; Compose Blender; Operating Instructions - Exquisit MU 8401swi Manual Del Usuario

EN

11.2 Set up blender

WARNING
If you place the blender improperly, it
•
can cause damage.
Place the blender on a flat, dry and
•
non-slip work surface. The work area
should be easy to clean, since you can
not always prevent splatter.
Don't place the blender on or near the
edge of the working surface.
Never place the blender on or near hot
surfaces (eg. hobs, heating pipes, etc.).
Note that the surface coatings of
furnitures sometimes contain chemical
additives which affect and soften the
suction cups of the blender. In this way,
residues can arise on the furniture
surfaces. Therefore, place a non-slip
surface under the blender.
The drive unit 5 is equipped with suction
cups which provide a secure grip for the
blender.
Set the blender up that it is easily
accessible and near a power outlet.

11.3 Compose blender

Improper handling of the blender or
individual instruments can cause serious
injury.
Turn the blender off when you assemble
or disassemble the blender.
The blender has two safety devices. It can
only be used with a properly attached
mixing bowl and properly attached safety
covers.
See Fig. 1 and 2
1. Screw the blade base securely to the
blender jug.
2. Place the blender jug on the drive
unit.
3. Ensure that the seal ring (5) is
correctly positioned in the blade
base.
4. Place the blade base on the drive
unit and turn in clockwise direction
to lock.
The blender jug (4) has a triangular mark
on the lower end. The drive unit (8) also
has a triangular mark (see Fig. 3 and 4).
1. Place the blender jug onto the drive
unit so that the triangles on blender
Seite | 18
jug and drive unit are aligned.
2. Turn the blender jug in clockwise
direction, holding the drive unit
firmly. The blender jug must engage
tangibly and audibly.
3. Place the safety lid (2) onto the
blender jug in such a way that the
long protrusion is positioned to the
right of the handle as seen from the
handle.
4. Turn the safety lid in clockwise
direction as far as it will go. The long
protrusion is now in the handle (Fig.
5).
5. Place the lid insert into the filler
opening so that the two lugs of the
lid insert fit into the recesses in the
filler opening, then fix the lid insert
by turning in clockwise direction as
far as it will go.
6. Push the battery into the battery
holder (Fig. 8).
7. Connect the charger cable to the
charger socket, and then the charger
to a mains plug socket.
8. The blender is ready for operation.

12 Operating instructions

WARNING
• Improper handling of the blender or
individual instruments can cause
serious injury. Do not touch the knife
with bare hands, the blades are very
sharp.
• Do not remove the safety cap until the
blades have completely stopped.
• Do not change the location of the
blender while the blender is running.
Make sure that hands, hair, clothing,
jewelry or another object during the
mixing process, and as long as the mixing
container is located on the drive unit, are
not getting in the jug. Always make sure
that the speed controller is at level "0"
(off) before connecting the blender to a
socket.
WARNING
When processing hot mixing goods, it can
cause scalding.
Do not put hot or boiling mixing goods
(such as soups) in the jug.