Adjust Speed; Use Blender - Exquisit MU 8401swi Manual Del Usuario

WARNING
Improper handling of the blender can lead
to damage of the blender.
Take note of the level marks. Fill the
•
mixing bowl at least to the lowermost
mark (250 ml) and do not exceed the
"MAX" (1500 ml) mark.
Do not operate the blender without
•
mixing goods.
Observe the maximum operating time
•
of 60 seconds.
A too long operating time can lead to
•
overheating of the engine. Allow the
blender to cool on room temperature
before using it again.
Before turning on the blender, make
•
sure no cutlery or the like is in the
mixing bowl.
Do not place over-sized pieces in the
•
blender jug.
Make sure when you use frozen fruit
•
that you always use the fruit in small
pieces.
• Do not mix nuts in shell or seeds.
Always remove any existing stems or
•
stalks from mixing goods before you
start the mixing process.
Do not place meat in the blender.
•
Never open the safety cover during
•
the mixing process.
Clean the mixing bowl after each use
•
as described in "Cleaning".

12.1 Adjust speed

The speed control is used to select
between two speed levels "1" and "2" a
pulse level "P" as well as to turn off the
blender, level "0".
1. Start the mixing process at the lowest
speed "1".
2. Later set the speed on the higher
level.
3. You turn off the blender, if you set the
speed control to the "0" level.
4. If you set the speed control to the
pulse level "P", you are using the
pulse function. Refer to the section
"Pulse function".

12.2 Use blender

To facilitate the handling of the blender,
the blender container 3 is provided with
level markings. The numbers indicated
there refer to the respective level in
milliliters. The lowest mark has no level
indication.
It corresponds to a level of 250 ml.
1. Operate the blender with at least 250
ml of liquid.
2. Do not fill more liquid in the blender as
the 1500 ml mark "MAX".
3. Always cut solid ingredients before
adding it in the bowl in small pieces so
you prevent jamming of the knives. If
you want to process solid and liquid
ingredients to the blender at the same
time, first enter the liquid ingredients
into the mixing bowl and mix the
ingredients.
Then enter the solid, finely chopped
ingredients, and continue the mixing
process. In order to obtain the structure
of the food, it is best to do the mixing
process in a few seconds.
1. Assemble the blender jug onto the
drive unit as described in "Compose
blender".
2. Remove the safety cover by turning it
counter-clockwise, until you can take
it off.
3. Fill the desired ingredients into the
blender jug.
4. Close the jug with the security cover.
5. Make sure that the speed control is set
to "0".
6. Connect the blender to a properly
installed socket.
7. To start the mixing process, turn the
speed control slowly up, until the
desired speed is reached.
8. To stop mixing for a while, turn the
speed control to level "0".
9. Wait for a complete stop of the blades
before you take the safety lid off.
Ingrediens refill
During the current mixing process, you
can add other ingredients.
1. Turn the lid insert counter-clockwise
until it stops and take it out.
2. Fill ingredients through the filler or
add small amounts of liquid.
3. Use the lid insert to refill other
ingredients.
Use the cover as a measuring cup. It is
suitable for measuring 30 ml, 40 ml and
50 ml of liquid.
EN
Seite | 19