Troubleshooting - Exquisit MU 8401swi Manual Del Usuario

EN

16 Troubleshooting

Error
The jug is not sitting correctly on the
drive unit.
The security cover does not sit correctly
on the mixing bowl.
The power cord is not properly
connected in the socket.
The blender is
not functioning
The socket has no electricity.
Missing/not fully inserted battery
Appliance overheated
(4 red flashing lights)
Appliance malfunction / damaged
battery
The blades do Empty battery
not rotate. (1 red flashing light)
Motor overloaded
(4 red flashing lights)
Battery cannot Mains plug is not correctly plugged into
be charged the plug socket.
Damaged battery / damaged charger
cable
When in doubt, consult a qualified expert.
Seite | 22
Possible reason Solution
Set the speed control to level "0" and
unplug the power cord from the
socket.
Put the jug on the drive unit, as
described in "Compose blender".
Set the speed control to level "0" and
unplug the power cord from the
socket.
Place the safety lid on the blender jug,
as described in "Compose blender ".
Connect the power cord correctly to a
socket.
Check the socket by connecting
another device.
Inserting the battery into the battery
connection
Turn the speed controller to "OFF",
remove the battery and allow it to cool
down before using the appliance
again.
Turn the speed controller to "OFF" and
remove the battery. Contact a
qualified person to have the appliance
inspected.
Turn the speed controller to "OFF",
connect the charger cable to the
charger socket, and then the charger
to a mains plug socket. Put the
appliance into operation again as soon
as the battery is fully charged.
Turn the speed controller to "OFF",
remove the battery and allow the
appliance to cool down.
Connect the mains plug to a plug
socket in the prescribed manner.
Disconnect the charger from the mains
plug socket, then the adapter plug
from the charger socket, remove the
battery and contact a qualified person
to have the appliance inspected.