Cleaning; Disposal Of Old Units - Exquisit MU 8401swi Manual Del Usuario

EN
1. Close the safety cover 2 with the lid
insert.
2. Turn the lid insert clockwise until it
clicks.
Using pulse function
The blender has a pulse function. It
means short operation at full power. By
using the pulse function is the maximum
speed is immediately available.
Use the pulse function if you want to mix
for a short time but intense. For example,
for foaming a liquid, or for crushing ice
(see "Crush ice cubes").
In order to enable this feature,
1. Turn the speed control 6 to the pulse
level "P" and hold it in this position for
as long as you want to mix. Use this
function only sporadically and never
exceed the maximum operating time.
2. Stop the mixing process by releasing
the speed control.
Crush ice cubes
1. Fill ice cubes into the blender jug 3.
Do not crush more than 10 to 12 ice
cubes per mixing process. Make sure
that the ice is not greater than 2.5 cm
edge length. With a small amount of
ice cubes, you get the best results.
2. Close the mixing bowl with the safety
cover 2 and the lid insert 1 (see
section "Compose blender").
3. Set the speed control 6 to level "0".
4. Connect the blender to a properly
installed socket.
5. Turn the speed control several times
for a short time to the pulse level "P"
and let it go again.
6. To end the crushing operation, set the
speed control to level "0".
7. Unplug the blender from the socket.

13 Cleaning

WARNING
Improper handling of the blender can be
causing an electric shock. Water
penetrated in the housing can cause a
short circuit.
Turn the blender off, and remove the
power plug from the socket before
cleaning the blender. Make sure that no
water gets into the housing of the drive
unit.
Never immerse the blender in water.
Seite | 20
Improper handling of the blender can lead
to damage. Do not place the blender or
individual parts in the dishwasher.
Do not use abrasive cleaners or scouring
agents, sharp or metallic cleaning objects
such as knives and the like. These can
damage the surface.
Clean drive unit
1. Allow to cool the blender entirely.
2. Wipe the drive unit 7 with a dry,
possibly slightly damp cloth.
3. Rub the drive unit then dry. Use a soft
cloth for this.
Clean mixing bowl
The blades are very sharp. A touch of the
knife during cleaning can cause injury.
Use care and caution when cleaning and
drying the blender container and the
knife.
Do not touch the knife with bare hands.
1. Place the jug on the drive unit as
described in "Compose blender".
2. Pour some lukewarm water with
detergent into the mixing bowl.
3. Cover the mixing bowl with the safety
cover 2 and the lid insert 1 (see "Use
blender").
Set the speed control 8 to level "0".

14 Disposal of old units

This product
according
Waste Framework
2012/19/EU.
regulates the proper disposal of
the
environmentally friendly
prevent possible
consequences caused by incorrect disposal.
The symbol on the product or its packaging
indicates that this product may not be
disposed with normal household waste. The
user must return the product to/at a
collection point for
electrical and electronic equipment.
is marked
to the European
Directive
The Directive
product. The
disposal will
negative health
the recycling of