Klarstein Iceberg Pure Manual De Instrucciones página 27

Natural wind mode with wind speed Low
Low (50 s) – Medium (50 s) – Low (50 s) – High (50 s) – Low (50 s) – Medium
(50 s) – Low (50 s) – Medium (75 s) – Low (75 s) – Medium (50 s) – High (50 s) –
Low (75 s) – Medium (50 s) – Low (50 s) – Medium (25 s)
Timer functions
a) Start timer: When the air cooler is in standby mode, you can set the appliance start
time with the Timer button
• Press the Timer button to set a time of 1-15 hours.
• When the timer time has been set, press the Timer button again to exit the timer
setting mode.
• In the timer mode, other settings can also be made, such as wind speed, mode, etc.
b) Off timer: When the appliance is operating, you can use the Timer button
the time until the appliance is switched off.
• Press the Timer button to set a time of 1-15 hours.
• When the timer time has been set, press the Timer button again to exit the timer
setting mode.
c) Timer indicator lights: While the timer time is running, the respective indicator lights
(1h, 2h, 4h, 8h) light up according to the changing timer time.
NOTE: The timer function is not saved when the appliance is switched on and off.
Sterilising (UV light/Ionizer function)
You can set this function when the appliance is switched on or a timer has been set.
• There are two ways of eliminating bacteria: using the ioniser function (anions) or UV
light. Both functions can be activated simultaneously. However, you can also select
only one of the two functions.
• Press the Sterilising button
Sterilising button repeatedly to set the functions in the following order:
UV > Anions > UV + Anions > disable.
• The sterilising function can be saved.
Humidification
If the appliance is switched on or a timer is set, you can activate the humidification
mode.
• Press the Humidification button
button again to deactivate the function.
.
to set one or both sterilising functions. Press the
to activate the humidification function. Press the
to set
EN
27