Star Progetti HELIOSA 55 Instrucciones De Uso página 13

HELIOSA 55 - 1500 WATTS IPX5 WATERPROOF (cod. 55BX5 - 55FMX5)
• Revolving model for wall installation and 5 m electric cable
• For indoor and outdoor areas
• IPX5 protection rating - Totally protected against rain and water sprays (Patentend)
• Equipped with: 5 m electrical cable, schuko plug, stainless steel grid, brackets (photo a - b)
• Dimensions cm 46,5x14x22
• Net weight kg 1,90
Photo a) Photo b)
Foto a)
3. USES
• HELIOSA® HI DESIGN 55 is suitable for inside and outside areas.
4.TECHNICAL DATAS HELIOSA® HI DESIGN 55
*HEATED AREAS
The heated areas indicated can vary according to the installation height, the environmental conditions and the synergy produced
when several heaters installed. In the latter case results can be lower or higher.
5. INSTALLATION TO WALL
Install the heater on the wall at a minimum distance of 32 cm from the ceiling (see installation examples page 38). The height at
which the heaters are normally installed varies from 2.5 metres to a maximum of 2.8 metres.Wall mounting is the ideal solution to
achieve the best results in terms of heat with the reflector at a 45° angle and the heater perfectly horizontal. The appliance must
not be placed immediately below a mains socket.
6. POSITIONING OF HELIOSA® HI DESIGN 55
1.Aim the HELIOSA® 55 reflector in the direction required for the wall-mounted installation. The normal angle is 45° to the orizontal
plane.
2. Never install HELIOSA® 55 an inflammable surface or facing an inflammable surface.
3. HELIOSA®55 must be placed at a clear distance (line of vision) of not less than 2.0 metres from objects such as cardboard, fabrics,
curtains and windows. If used in workshops and garages where there are inflammable paints, HELIOSA® 55 must be located more
than 4 metres from the hazard.
4. We recommend that the heater is not used in dusty non-ventilated environments to avoid damage to the bulb.
15
Foto b)
13