Accuracy Check And Calibration - Stanley SML Manual Del Usuario

Accuracy Check and
Calibration
NOTE:
• The laser tools are sealed and calibrated at the factory to
the accuracies specifi ed.
• It is recommended to perform a calibration check prior to
its fi rst use and then periodically during future use.
• The laser tool should be checked regularly to ensure its
accuracies, especially for precise layouts.
• Transport lock must be in the unlocked position to
allow the laser tool to self-level before checking
the accuracy.
90° Vertical Beam Accuracy
(See fi gure )
K
NOTE:
• You will need at least 1,5 m
assistant for this check.
• Place the laser tool on a level fl oor, and turn on all beams.
• Measure exactly 0,91 m (3 ft) out from the center of
K
1
the laser tool along the front vertical laser beam. Mark
this point P .
1
• Measure exactly 1,22 m (4 ft) out the center of the
K
2
instrument along either of the 90° vertical reference
beams, and mark this point P
• Measure from point A to point B; this distance D
K
3
should equal 1,52 m ± 0,3 mm (5 ft ± 1/64 in).
• If not, the tool must be returned to your Stanley
Distributor for calibration.
• Repeat the above steps to check the other beams.
K
4
12
2 of fl oor space and possibly an
.
2
1
Level Beam Accuracy
(See fi gure )
L
• Place laser tool as shown with laser ON. Mark point
L
1
P at cross.
1
• Rotate laser tool 180° and mark point P
L
2
• Move laser tool close to wall and mark point P
L
3
• Rotate laser tool 180° and mark point P
L
4
• Measure the vertical distance between P
L
5
D and the vertical distance between P
3
• Calculate the maximum offset distance and compare to the
difference of D and D
3
• If the sum is not less than or equal to the calculated
maximum offset distance the tool must be returned to
your Stanley Distributor for calibration.
Maximum Offset Distance:
= 0,13 mm m x (D
Maximum
= 0,0016 in ft x (D
Compare : (See fi gure
D - D
3
Example:
• D = 10 m, D = 0,5 m
1 2
• D = 0,4 mm
3
• D = - 0,6 mm
4
• 0,2 mm m x (10 m - (2 x 0,5 m) = 1,8 mm (maximum
offset distance)
• (0,4 mm) - (- 0,6 mm) = 1,0 mm
• 1,0 mm ≤ 1,8 mm (TRUE, tool is within calibration)
at cross.
2
at cross.
4
and P
1
and P to get D
2 4
as shown in the equation.
4
m - (2 x D
1
ft - (2 x D
1
)
L
5
≤ ± Maximum
4
at cross.
3
to get
3
.
4
m))
2
ft))
2
77-322