Axis Q1615 Mk II Guia De Instalacion página 12

AXIS Q1615 Mk II Network Camera
Status LED Behavior for Focus Assistant
The status LED flashes when the Focus Assistant is active.
Color Indication
Red The image is out of focus.
Adjust the lens.
Amber The image is close to focus.
The lens needs fine tuning.
Green The image is in focus.
Buzzer Signal for Focus Assistant
Buzzer
Fast interval
Medium interval
Slow interval
Status LED Behavior and Buzzer Signal for Levelling Assistant
For information on the Function button used for levelling the camera, see Connectors and Buttons.
Press and hold the function button (2) for more than two seconds to level the camera.
• When the camera is level, both LEDs are steady green, and the beep is continuous.
• When the camera is not level, the LEDs flash a combination of red, green and orange, and
the beep occurs at slow intervals.
Both LEDs briefly flash green to indicate that the levelling is getting better.
Connectors and Buttons
For specifications and operating conditions, see page 15.
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
Lens
Optimally adjusted
Less optimally adjusted
Poorly adjusted
12