Further Information; Warranty Information - Axis Q1615 Mk II Guia De Instalacion

AXIS Q1615 Mk II Network Camera
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See Hardware Overview on
page 10.
3. Keep the control button pressed for 15–30 seconds until the status LED indicator flashes
amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90
5. Using the installation and management software tools, assign an IP address, set the
password, and access the video stream.
It is also possible to reset parameters to factory default via the web interface. Go to Setup >
System Options > Maintenance and click Default.

Further information

• For the latest version of this document, see www.axis.com
• The user manual is available at www.axis.com
• To check if there is updated firmware available for your product, see
www.axis.com/support
• For useful online trainings and webinars, see www.axis.com/academy

Warranty Information

For information about Axis' product warranty and thereto related information, see
www.axis.com/warranty/
22