Introduction; Product Features; Use; Assembling The Juicer - Cuisinart CCJ210E Manual De Instrucciones

1. INTRODUCTION

You have just purchased a Cuisinart® juicer.

2. PRODUCT FEATURES

1. Lid
2. Juicing cone
3. Sieve
4. Container
5. Spout with anti-drip system
6. Release mechanism
7. Motor base
8. Cord winder (not shown)
8

3. USE

A. ASSEMBLING THE JUICER
• Rinse the lid, the juicing cone, the sieve and the
container in warm water. Do not rinse the motor
base in water but simply wipe it using a damp cloth.
• Fit the container onto the motor base. The three
1
plastic notches located on the bottom of the
2 container are inserted into the three holes located
on top of the motor base.
3
• Position the juicing cone on the top of the release
4
mechanism.
• Place the lid on the container.
5
• Plug the unit in. The juicer is ready to be used.
6
B. USING THE JUICER
7
• Place the unit on a horizontal, level surface.
• Remove the lid.
8
• Place a glass or other container under the spout.
• Set the spout to the open position.
• Cut the fruit horizontally.
• Place the centre of the fruit on the centre of the
juicer. Place your palm on the fruit.
• Press the fruit down firmly enough to activate the
release mechanism.
• When you feel the juicing cone through the skin of
the fruit, remove the fruit.
• Take another piece of fruit and repeat.
• After juicing approximately 200 gr of fruit (the
equivalent of 3 oranges), the sieve will appear to be
full.
• Remove the fruit from the juicing cone and place the
lid on the juicer. Press down on the cover to activate
the 'fast spin' . This will release any juice remaining in
the sieve.